What bushing to use on a MEC 600 jr. mark 5!?!?! hurry!? - remington primers
Ok
I have not actually started in reloading (was), I have to choose a course and reaches for his help. I have a MEC 600 JR. 5 points Reloader 20 gauge. I will use 1 oz # 8 shot, Hodgdon HS-6 Powder, 209 Winchester primers, wads Remington SP20 and 23 grains of powder. What jack for use with my universal charge bar?
Thank you and Happy Shooting!
Alex
Sunday, January 17, 2010
Remington Primers What Bushing To Use On A MEC 600 Jr. Mark 5!?!?! Hurry!?
Subscribe to:
Post Comments (Atom)
3 comments:
Would it not be that came with the press?
Refer to the manual.
You should not try to always recharge. Also check 1 to 25, while I'm loading and make sure that I do what I need. I am a little confused, but .... My MEC 9000g I have cash, a general fee, but it does not use hubs. Therefore, its universal character. You have until the end, what you want. A progress bar uses standard sockets. You can find the CAP, you must have either the MEC or Hodgdon website. Sometimes the plug in the desired position. In this case, can take some fine sandpaper and run to the platform a little to get the right job to open. But do not care, to remove. Next to go to the nationwide use wherever you like.
Never trust a tube of powder exiting the amount of dust in the list. Get a powder-scale (low cost) and you can use or modify their caps or use the next size larger or smaller. Prevention is better than cure and you blow the weapon.
Post a Comment